neck shims for bass, shaped, set of 3 (0,25 / 0,5 /1 degree)

To change the angle of a bolt-on neck, players and repair shops have used shims for years. We’ve seen everything from matchbook covers to guitar picks stuck in neck joints. Those kinds of shims create an unwanted gap under the heel of the neck: a dead air space where humidity condenses to swell the wood. As Dan Erlewine describes in his Guitar Player Repair Guide: “This gap may cause an upward kink in the neck. And many players feel they lose tone unless firm contact is maintained between the neck and the body.”

Dan creates tapered shims that cover the entire heel of the neck. With these ready-made shims, that work is done for you. Attention, repair shops: making a quality shim takes time! Keep these on hand for a quick turnaround on this common repair.

Full contact and precisely tapered: this set offers 3 different degrees for changing the pitch of any bolt-on neck. 0.25-degree shim offers the most versatility. Stacking them will let you really dial in the neck angle you’re after. 0.5-degree shim is the one you’ll reach for most often. It works great on Fender and many other solidbodies. 1-degree shim is great for basses with a post mounted bridge.

Taper specs (approximate)
– 0.25-degree shim tapers from 0.030″ to 0.019″ (0.76mm to 0.48mm)
– 0.5-degree shim tapers from 0.044″ to 0.010″ (1.11mm to 0.25mm)
– 1-degree shim tapers from 0.078″ to 0.010″ (1.98mm to 0.25mm)

Dimensions:
– 2-1/2″ x 3-7/8″ (63.50mm x 98.43mm)

These shaped shims fit most neck pockets with a rounded heel.
Made of solid maple to match the neck.